How Do I Adjust the Flow Rate of Shielding Gas?

Whenever you are using a welding machine, like a MIG welder or a TIG welder, it is crucial that you know how to adjust the flow rate of shielding gas. When assembling and setting up your welder, once you connect your shielding gas regulator, the gas flow rate must be adjusted in order to assure that the right amount of shielding gas is flowing over your weld. If too little gas is flowing from your welder, excessive spatter and contamination can occur. If too much gas is flowing, you will be wasting your gas, which can negatively affect the result of your weld. Typically, there are two gauges on the shielding gas regulator, one to mark the gas flow rate and one to mark the gas tank pressure.

The first thing to do to adjust the flow rate of your shielding gas is open your shielding gas tank valve the whole way. Adjust the knob on the regulator so that it is marked at about 30 CFH. Now, turn on the welder and trigger the torch switch so that the gas will start to flow. When you trigger the torch switch, the gas flow should cause the needle on the gas flow gauge to descend to a steady and accurate reading. Next, the gas flow should be set to about 20 CFH when it is flowing, which is the most common flow rate used when welding. Sometimes this needs to be readjusted as a slight breeze could alter the flow and weaken the shielding gas consistency surrounding the weld. Once you have adjusted the flow rate, you are free to weld. Just remember to close the gas valve on the bottle when you are finished welding.

To learn more about welding and for more automotive FAQs, be sure to visit

One thought on How Do I Adjust the Flow Rate of Shielding Gas?

  • Making sure your tank is shielded is really important! I used to not think so and I was a little reckless with how I stored my gas. I then had to deal with an explosion and fire and that quickly changed my mind about safely storing my gear. Great reminder.

Leave a Reply