Welding on Axle Housing Tubes?

Posted: November 29, 2015 By: james j

Home Forums Kevin Tetz’s Korner Welding on Axle Housing Tubes?

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #36031

    james j

    Member

    Hi Kevin,
    I just wanted to get your thoughts on welding on an axle housing’s tubes. I have a Chrysler 8.75″ rear going into a Charger with the leaf spring relocation kit. The new leaf spring pockets are already installed in the frame rails, but I have the new leaf spring perches just tacked in place on the rear end (which still has its axles in it). As such, I just wanted to see if you have any advice on how to finish the welds on new perches. I figure that it would be easier to ask, since I am concerned about warping. The rear end still has it’s original axles in it, but they will be replaced before they go back in the car. …I know that you did something welding for reinforcing on the Zed’s rear end, which made me think of asking.

    Any hints or advice would be greatly appreciated.

    Thanks,

    James

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed