Suggestions??

Posted: November 30, 2006 By: Tate

Home Forums Powder Coating Powder Coating Archives Suggestions??

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #30510

    Tate

    Member

    I have a guy who is very very particular about getting an absolutely perfect finish on a few motorcycle parts I’m doing for him. I’m doing them in flat black.

    I’m having a little bit of an issue, the finish comes out near perfect all except for these tiny little specs that look like a very tiny grain of sand. Normally most people are fine with that because there’s only like 1 every 10 square inches or so but this guy will want it re-done even if there is 1!

    Personally I think it is a tiny little clump of powder not sand or dirt…

    Any suggestions on how to avoid them??

    Thanks
    Tate

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed