Soda blaster setup
- This topic has 0 replies, 1 voice, and was last updated 11 years, 3 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I recently purchased the Eastwood Soda Blaster (50095) and opened the box to set it up today. It includes the Retro Fit kit, but I cannot figure out how to rig that. The instructions were not adequate to figure it out. Is there a video or web page that shows in detail how to swap out the abrasive setup for the Soda kit? Thanks for any direction on this.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.