Small Parts

Posted: March 23, 2010 By: magnum

Home Forums Powder Coating Small Parts

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #32291

    magnum

    Member

    I am starting to make some small aluminum parts and would like to powder coat instead of anodize if possible. Only problem is these parts may have areas that are difficult to spray in and coat evenly. To visualize these parts think of two small plates about .125 apart and the inside of these plates need to be coated., probably no deeper than .25 inch.

    I am new to powder coating, but I think in the long run will be better for my parts than messing with all of the acids for anodizing.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed