Rust in the seams!
- This topic has 0 replies, 1 voice, and was last updated 16 years, 5 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I would like some advice on treating the rust that I know exists in the seams of my classic Mustang. I’m talking about the seams where sheetmetal has been attached to sheetmetal via spotwelding. Mostly in the back of the car and underneath. Do I need to separate all of these panels or is there another way to handle this?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.