removing abrasive from sandblasted valve covers/manifolds?

Posted: March 19, 2011 By: scott0999

Home Forums Powder Coating removing abrasive from sandblasted valve covers/manifolds?

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #33498

    scott0999

    Member

    I normally sandblast everything before I powder coat it. on valve covers or intake manifolds the abrasive always gets stuck in the oily surface

    I’ve been submerging the parts in hot water, pre heating in the oven to release some of it, blowing out with air, ect. but it seems like it doesnt all come out.

    how do you guys prep these parts?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed