redoing rubber side molding

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #32592
    Amopower
    Participant

    What products would I need to prep a flexible rubber molding, the kind that go down the side of a car. Mine is held on by what appears to be double sided adhesive tape. The rubber molding was repainted at one point but now it looks terrible, as the paint is wrinkled and bunching up. I’d like to strip that bad paint job off and start over, but was worried about what solvents would be safe to strip that paint off, without compromsing the rubber molding itself. I’m sure not all solvents are safe to use on rubber and might soften it up and make a real mess.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button