Question about coating bolts

Posted: April 30, 2006 By: dfurlano

Home Forums Powder Coating Powder Coating Archives Question about coating bolts

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #29222

    dfurlano

    Member

    New to power coating. I have some very small #0 brass hex head bolts that I tried power coating gloss black. The coating want on evenly but when they dried you can see that the coating is very thin at the points of the hex. It looks like the coating flowed away from the points to towards the center flat area. I am not sure if I over heated or left the parts in the oven to long of is the bolts were not cleaned enough and the coat had a hard time staying in place.

    I am going to try again but I thought if anyone had experienced this I would greatly appreciate suggestions.

    Dan.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed