problems

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #34910
    Marques
    Member

    When I powder coat I am not getting the results that I need.The powder seems to chip some what after some use.I thought it would be as hard as a rock coating.I sand the bare new metal wipe it off with acetone and blown it off with air.I bake it in the oven at around 375/400 for about 25 minutes and it comes out looking great but it is not holding up like I thought,am I doing something wrong??

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button