Problem with Eastwood 135 mig

Posted: September 20, 2015 By: Goingyard33

Home Forums Ask Eastwood Problem with Eastwood 135 mig

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #36036

    Goingyard33

    Member

    I just got my brand new Eastwood 135 mig/flux core welder in the mail on Friday. I set it all up to use .035 flux core wire. Reversed the drive roller and reversed the polarity. I became some
    Practice beads on some scrap 16 ga. And it did fine for the first 8 welds then it totally quit feeding wire. No clicks! The roller does not spin. I’ve tried everything I can think of. The light on the front stays on and so does the fan. I’m at a loss. Any help would greatly be appreciated!! I’ve tried Eastwood tech support but they aren’t open on sundays

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed