Primer Question

Posted: March 26, 2006 By: SVTforme

Home Forums Powder Coating Powder Coating Archives Primer Question

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #28931

    SVTforme

    Member

    Hi,

    I am new to this forum and the primer powdercoat, but have been using the Eastwood system for many years.

    Question is.. I recently purchased the new primer product and attempted to use it today. I put it on like any other powder, and then came to find that the next coat does not adhere at all. After searching these forums, it seems as though you are supposed to stop after the part begins to flow out, cool and the put on the next coat. Nice to know ;).

    Problem is, I have the primer fully cured on my parts and want to know the best method going forward on this one. Can I just sand this and recoat.. or do I have to strip it and start over or.. Any suggesestions would be greatly appreciated.

    Thanks!!

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed