powdercoating over powdercoat

Posted: May 4, 2011 By: r1nstang

Home Forums Powder Coating powdercoating over powdercoat

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #33605

    r1nstang

    Member

    I was powdercoating a part the other day and didnt realize I i put it in the oven that it just barely rubbed the bottom which caused the powder to look thin in some spots and gone in other spots. The part has already been baked and cured. is there anyway to PC over PC? if I mask off the area that is already coated spray the “bald” spot then remove the take and bake would it be fine? or would the first coat of PC burn or bubble up?

    I’m using the low end eastwood gun that came with the PC kit and 3 colors. its not a dual voltage.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed