powdercoating alloy wheels

Viewing 1 post (of 1 total)
  • Author
  • #32870

    Some time ago, I had inquired about powdercoating older aluminium wheels. I was advised byan Eastwood moderator that the wheels may get brittle after the baking process. Based on that, I declined the project.
    Now, I have been approached about coating some newer alloy wheels. They are less than 10 years old, from a Toyota truck.
    That’s about all I know about them at this point.
    So, the question becomes, are newer alloy wheels subject to the same possible brittleness as the older, alumninium wheels?
    I appreciate your advice on this, as brittleness is not a quality I wish to have in a wheel.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button