[h500r]

I am having problems with powder not wanting to stick to parts
before baking , I have tried all different kinds of prep, and different
metals , I have current going thru the parts, I just tried to powder
some sheet alumium panels , you could actually see the powder sliding
right off the parts , It will stay on if I keep at it , I did 4 panels
6 foot long and 4 foot wide and used 2lbs of powder , most of it was on the floor , they looked good when done , just seems like alot of waste , that going to the floor , I do not know if this is normal or not , any help ??

[Author]

Posts