Powder coating small brass parts – advice needed.

Posted: April 2, 2014 By: jenkznza

Home Forums Powder Coating Powder coating small brass parts – advice needed.

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #35170

    jenkznza

    Member

    I paint hundreds of small brass parts each week and am trying to find a more efficient approach. These parts are roughly 1/2″ long by 1/4″ in diameter with a 0.055 hole running through the center. Currently I hang these one by one on a wire then heat them and dip them in a fluidized bed of powder paint. The approach works, but is extremely time consuming.

    Is there a way I could do this more efficiently with the Eastwood system. Keeping that hole open is a concern also.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed