Painting over a little rust on a master cylinder

This topic has 0 replies, 1 voice, and was last updated 11 years, 3 months ago by golivier.

Viewing 1 post (of 1 total)

Author

Posts
May 13, 2011 at 12:03 pm #33670

golivier
Member

I have an old master cylinder that has been blasted but there is some rust left in pitted areas. Should I use converter, then encapsulator, then brake gray, or am I fine just using pre, then the brake gray?
Author

Posts

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.