New TIG and Plasma Cutter will not arc.

Posted: November 14, 2012 By: InfotechBrewer

Home Forums Ask Eastwood New TIG and Plasma Cutter will not arc.

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #34559

    I just got tig and plasma yesterday, both will not arc. Tried on several outlets. My 220v will not be installed until the weekend but both should at least give me at least a small arc on 110. Is the green power light supposed to be on the front of the welder and plasma cutter.

    On the TIG the fans are on and I can hear the pre and post gas flow but no arc at all. Fans are working also on the Plasma. I know the ground is good. FYI my 2 mig welders work fine on the same outlets.

    I am only getting voice mail the several times I called support. I really needed these working by the weekend :/

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed