New Gun

Posted: April 5, 2014 By: wojtek90

Home Forums Powder Coating New Gun

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #35177

    wojtek90

    Member

    I just bought Eastwood dual voltage powder gun.
    I did firs part . Came out not too bad.

    I am not sure that voltage is delivered to my part during coating process.
    I have question regarding it. On the power supply is red round switch for high for high voltage and low voltage.
    It is supposed to light on when power supply is connecting?
    How can I check that my part is connected and voltage is deliver to the surface of coated part?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed