Mig Welding with Hobart 125?
- This topic has 0 replies, 1 voice, and was last updated 16 years, 2 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I am trying to weld in a patch panel on my pickup bed. My welder is a Hobart 125 Mig welder. It’s a 110 volts. I turn it to the lowest voltage setting which is 1 and the wire speed is set to 10. I keep getting blow thru…spatter…and spitting. I am using .030 self sheilding wire with this setup. If someone can give me some tips I would greatly appreciate it.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.