mig welder wire feed problem

Posted: February 21, 2011 By: healey guy

Home Forums Ask Eastwood mig welder wire feed problem

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #33407

    healey guy

    Member

    I purchased a mig175 about 6 mos ago, haven’t used it for about 3 mos. Wire feed motor does not work at all or runs for about 3 seconds then quits. I released the wire tensioner spring to see if there was too much wire rolling resistance, but same problem continues. Is this a defective motor?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed