Mig 175 wire feed motor

Posted: October 27, 2012 By: mroll004

Home Forums Welding Mig 175 wire feed motor

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #34535

    mroll004

    Member

    Recently purchased a mig 175 and i am having trouble with the wire speed motor. It starts out at the correct speed and after about 3 or 4 seconds decreases feed speed dramatically, it also has an intermittent delay. At first i thought my spool was too tight but the motor is still acting up when there is no wire running through the roller. I have sufficient power at the wall. Any suggestions? :confused:

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed