mig 175 not working
- This topic has 0 replies, 1 voice, and was last updated 8 years, 10 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I have an Eastwood mig 175 welder. It has worked flawlessly in the past. I believe I bought it about 2yrs ago.
The problem is I have no wire feed. I can turn amps and feed to max and still zip, nutn.
I replace the dive motor and still nothing. When I apply voltage (220) the fan comes on, I get a red and a green led lighting up on the circuit board.
I think the capacitor is bad. I read zero volts across the terminals, and I also get no reading when I check the capacitance.
Any help would be greatly appreciated.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.