Mig 135 defect?

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #34571
    DudeAbides
    Member

    [ATTACH]4085[/ATTACH]Just tried to set up my new Mig 135. After hand feeding the wire over the drive roller and through the torch hole it would stop dead like it hit a wall. I pulled the end of the gun out to inspect and found the torch hole for the wire is not centered in the hole the gun plugs in to so the wire can’t feed into the gun when it’s plugged in! I confirmed that wired feeds freely into the gun when its not plugged into the welder.

    I don’t see any adjustment options to center the wire feed in the hole. Any help?

    [ATTACH]4084[/ATTACH]

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button