leave bearing race in hub while PC…???
- This topic has 0 replies, 1 voice, and was last updated 16 years, 7 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Is it possible to leave the inner bearing races inside a motorcycle wheel hub while powder coating the hub?
It seems like it should be taken out to avoid any chance of warping….
Is there any danger of that @ 400 deg…?
new to powder coating, hobby only for M/C resto,
have gotten a lot of good info from everyone on this board so far…
thanks to all
Tony