Lead Pits

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #30599
    hr41pearl
    Member

    Well, like most things, it takes a while to understand all the little tweeks with most products. I have found the leading thing a real challenge and yet fun to some degrees. Well kinda.

    I am having problems getting the lead to hold in the pits between weld spots. I have ground the welds as flat as possible with out damaging the metal, but I still have low spots and pits that I want to fill in before sending the unit out to powder coating again. I think the problem is in the tinning. I am having a hard time getting it down into the cracks so the lead will stick better.

    Does anyone have experience or comments that might HELP ME?

    hr41pearl 😎

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button