Is my powder "burning"?
- This topic has 0 replies, 1 voice, and was last updated 11 years, 8 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
I just got done with my oven build and shot a couple things for a friend. The small parts I did in my toaster oven and the big parts in the new oven. The toaster oven parts came out nice and bright white while the big oven parts are a “off white”. So, I shot two scrap parts and put one in each oven. The big oven parts got much hotter, 420* vs 330*, even though I had them both set at 400*. Is it possible the parts got too hot and “burnt” the powder a bit? I attached a pic.
Thanks.