Imron – Powder
- This topic has 0 replies, 1 voice, and was last updated 15 years, 4 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Ive been sandblasting then priming with Variprime and then topcoating with Imron the doors and frames on engine drive welders that i restore. Im considering sandblasting then taking the parts in to get powdercoated. Im most concerned with preventing rust on the parts in the future. Whats your opinion?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.