How to make a tight radius ‘J’ lip

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #27865
    truggier
    Member

    Hi, I’m working with 16 gage aluminum sheet (3003) and want to know the best way to put a 0.2 inch diameter ‘J’ lip on the edge of the part I’m making. See the attached two pictures for details.

    I was thinking of using a T-Dolly and a mallet but the T-Dollies you sell only go down to 1/2″ diameter. This needs to be tighter. Any ideas?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button