Help solve blemish problem
- This topic has 0 replies, 1 voice, and was last updated 12 years, 10 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Sure glad that the Forum is back up and running !
Below you will see a blemish on on a part that I did recently. This is Eastwood powder, “Red Wagon”. I did a number of parts this day, and only this part has tree of these marks. Although the part is assembled, it needs to come apart and be sand blasted again – all of it ?? and PC again.
Could this be moisture ? Lots of rain lately, and my water filter on my compressor is very small. Or is it something else ?
Thanks Roy