Golf clubs- yes, golf clubs

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #33891
    Xramcam
    Member

    I have been experimenting with powder coating putters and irons lately with great results. I am using textures, metallics, and usually clearing them. My question is this: I am filling in the name, degree, etc on the club with enamal. The problem is that I get more on there, and somehow have to wipe it off without smearing it everywhere. I use acetone, but it tends to soften the clear. I tried letting them dry and then use an SOS pad, but the gloss comes off with it. Any good suggestions out there?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button