Fingerprints

Posted: November 20, 2006 By: BeeBob

Home Forums Powder Coating Powder Coating Archives Fingerprints

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #30450

    BeeBob

    Member

    I’m new at this so please bear with me. My first attempt at pc ing was with ew single stage chrome. I did everything by the “book”, after the piece had cooled ( metal parts tray ) I picked it up bare handed and left fingerprints on the piece! They wiped off fairly easy with a clean rag, but then I had wipe marks that don’t come off. The part wasn’t as shiny as alot of the parts I’ve seen on this site, so should I put more powder on before baking? The powder “cloud” out of the gun didn’t seem thick enough to me at 8 psi and @ an inch and a half deep in the cup, but the part was completely covered. I think I’ve seen somewhere about leaving the oven door ajar while baking to let the smoke out for certain colors to help prevent filming over. Thanks for any help………

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed