Evo cam bearings at 400 degrees?
- This topic has 0 replies, 1 voice, and was last updated 17 years, 6 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Hey,
I am planning on buffing and coating the aluminum covers on my bikes engine. The cam cover has bearings pressed into it, does anybody know if they will have issues with the 400 degree cure temp. I could have my dealer pull the bearings before I coat the cover, but I am worried about them mucking up the coating when they press them back in. Also one less step wouldnt hurt (could it?).
Thanks.