Eastwood mig welder 135 110 stopped feeding wire

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #35227
    pandabear
    Member

    The second time I tried using my new 135 eastwood welder it stopped feeding the wire. I followed the instructions on another forum about the same problem. The tech said to loosen the three screws and try it which when I did the feeder wheel will turn, but when I tighten it back up it will not turn. Any suggestions?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Back to top button