Dull finish. Too hot??
- This topic has 0 replies, 1 voice, and was last updated 10 years, 4 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Hello. I am new to powdercoating, but attempted my first part today. It was a gas cap that is approximately 3″ in diameter. I was using high gloss black, but the part turned out dull like a flat or satin black. Otherwise it looks pretty good and the finish seems very durable. I believe I may have overheated the part to approximately 500 – 520F. Could that cause the flat finish? Is it possible that the powder was mislabled and is actually flat black?
Thanks in advance for any advise or help.
[ATTACH]3877[/ATTACH]