Cutting/Welding pans
- This topic has 0 replies, 1 voice, and was last updated 12 years, 6 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hello to all!
I’m replacing the front half of the drivers side floor pan on my 84 Mustang. I’m putting in new metal forward of the seat brace.
My question is about supporting the body/frame while cutting out the old pan and welding in the new one. Can I leave the car on its wheels or should I support it up in air on jackstands? How about up on a set of ramps? Obviously, I don’t want the body to flex while the pan is out. Thanks for the info!!
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.