Copper/nickel lines and Flare tool
- This topic has 0 replies, 1 voice, and was last updated 11 years, 2 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I have the pro flaring tool and it seems to do a reasonable job on steel but copper/nickel lines do not work well it puts creases in the flare. Picture attached. These are among the worst, some are a little better but they are really no good… I looked at the video and I saw a message that implies this tool works only with steel lines. I s that correct?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.