chrome and clear procedure ?
- This topic has 0 replies, 1 voice, and was last updated 12 years, 5 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
I am going to do my coil springs and bought the EW reflective chrome powder and the EW full gloss clear . What is the best way to do this ? I read the little insert that says both of these powders are cured @375 degrees for 20 minutes after flow out . I guess my question is do I shoot the chrome on the springs and bake until it’s cured , then shoot the clear on them and bake the same way and temp as the chrome ? Does the clear powder stick to the chrome since it has a metallic composition ? Does the chrome not melt while curing the clear because it has already been cured ? Thanks in advance for the help. :confused::D