CFM Requirements
- This topic has 0 replies, 1 voice, and was last updated 17 years, 3 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
I own a 5 HP Coleman compressor. It is rated at 7.3 cfm at 90#’s of pressure. Recently I purchased one of your orbital sanders. When I went to use it yestereday, it would spin freely, but would almost immediately stall, when I touched the disk to the surface [it this case fiberglass].
What do you think is the problem? Is my compressor too small?
Thanks.