Another Noob with a question…
- This topic has 0 replies, 1 voice, and was last updated 12 years ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
I have already learned a lot lurking around the forum for the past few months and wanted to say Hello, and thanks…
I am getting ready to coat a set of fabricated valve covers and wanted to know if there should be any extra steps that I would need to take in order to get the coating over the welded areas to look just like the rest of the metal. Can I just coat over the welds and expect them to have the same finish as the rest of the part?
I’ve done about 30 steel parts and a few cast aluminum parts with good results, but none of the parts have had any welds in them…
Thanks in advance!