Aluma Blast question
- This topic has 0 replies, 1 voice, and was last updated 16 years, 3 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I have the idea of painting my new cast iron heads with Aluma blast. Will it hold up to the temps that an engine gets up to? On place says 250 deg. and somewhere else I read 300. I hope my heads never reach over 250, but around the exhaust I am sure it gets a bit hotter. What should I primer with if it will hold up to the temp?
Thanks
Rob
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.