4runner quarter panel patch question

Posted: August 11, 2005 By: BobJ

Home Forums Projects Projects Archives 4runner quarter panel patch question

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #27416

    BobJ

    Member

    Hello, I have cutout some 22gauge sheet and will be butt welding in rear quarter patch. I have left about 3/4″ inch excess around wheel well and was going to to make a whole bunch of “slits”, then try to dolly it over. Is there a better way of dealing with this? I would like patch to go over factory wheel well lip, but I guess not 100% necessary? I have spent a lot of time eliminating gap where patch and quarter panel meet, so would like to do it right first time and not make another panel. I welcome your thoughts and ideas on the matter.

    Thanks, Bob.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed