2nd colors….yet again

Posted: October 21, 2006 By: Rufus

Home Forums Powder Coating Powder Coating Archives 2nd colors….yet again

Viewing 1 post (of 1 total)
  • Author

    Posts

  • #30246

    Rufus

    Member

    Ok, so i have figured out that you need a good ground for doing 2nd coats, right? Right. My question is…how do you handle the parts before the 2nd coat is applied? For the pros i guess you’re letting the part cool to room temp, then taking the hanging wire off, grinding out a new ground point, and reattaching? Are you wearing gloves at this point? Do you re-clean the part after re-hanging or re-masking? Not sure if you can safely spray (insert cleaner of choice here) on the freshly cured part… If you’re going to shoot the part warm, then do you heat it back up? Thanks.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Top Selling Products

Comments are closed